What comes with the mid engine

Super Speedster body/frame kit ?

UNDER CONSTRUCTION

The mid engine Super Speedster assembly package is designed to be very DIY user friendly not only in the ease of assembly, but also allowing procurement of most of the finishing components only when you need them and from whom you wish to buy.  This keeps initial cost down and paced as you finish the car.

This DIY Super Speedster kit is for the enthusiast who not only wants the gratification of successfully building his own car, but also ending up with a true sports car with proper balance, handling, braking, and safety

 

A structural welded frame (not a sub frame) - AWS certified weld shop

  • completely painted with black epoxy coating
  • attached welded steel floor pan
  • welded steel firewall and foot well shields
  • all connection points accurately located and drilled for your front and rear suspension
  • mounting holes located for your steering rack
  • 2 unique adjustable rear trailing arms
  • 2 unique rear adjustable tie rods
  • 2 front macpherson strut carriers and cartridges
  • bolt-in engine/rear suspension cradle (engine and suspension removed from below)
  • attaching holes drilled for your 3 point seat belts
  • mounting holes located for your driver/passenger seat 
  • fiberglass floor tunnel
  • brake hose connection tabs mounted
  • speedometer cable spindle adapter
  • support beam for your steering column and park brake handle
  • all attaching bolts and nuts for your suspension components 
  • Mounts located and welded  for your VW Type 3 engine and transaxle 
  • mounting holes located and drilled for your Brake Booster/master cylinder and clutch cylinder

 

A  356A Speedster Fiberglass Body - Assembled

  • Non flared 356A Speedster replica body mounted to frame (can be removed)
  • hand laid in USA using only the highest quality isophthalic (iso) resins and gelcoats
  • doors fitted, hinged, and latched
  • doors inner steel reinforced
  • Hood fitted, hinged, and latched with pull cable release
  • Deck lid fitted, hinged, and prepared for latch (Subaru donor part)
  • Interior door latch releases and handles installed
  • Cockpit fiberglass engine cover lid with over center latches
  • Trunk mounted fiberglass pedal access cover
  • marked cut outs for your tail lights, headlights, park lights, horn grilles  (leaves option for changes)
  • 2 Headlight dust buckets
  • Front and rear fiberglass bumpers (not installed - leaves option of omission)
  • Windshield post holes located and drilled
  • Body coated with sandable gray polyester primer

 

NOTE: 

It is expected that the body will be removed from the chassis while chassis work is being completed.  Simultaneously the removed body will be sent to a facility for painting.  When the chassis work is completed the painted body can be lowered back onto the chassis and attached as it was delivered.

 

A parts and sourcing list for the remaining non-supplied parts